Project Ideas

Delta benchtop drillpress for metalworking

About

Features

• 1/3 HP motor
• 5 speeds
• 6-1/2 inch throat
• 12 inch height under spindle

Safety

Safety Procedures

• Keep fingers clear when operating!
• Wear eye protection
• Clamp material to the table or use a vise whenever possible

Getting Started

Materials

Can be used to drill most materials, including metals and plastics, as long as aa suitable bit is used.

Power and Speeds

1/3 HP motor

5 speeds – adjustable by moving the belt to different pulley pairs

Tips and Tricks

Notes

Owner	Fox.Build
Manufacturer	Delta
Model	11-990
Serial #	R9019
Product Website
Instructions
Size/Volume	6-1/2″ Throat

Project Ideas

Eastwood Throatless Shear

Owner	Fox.Build
Manufacturer	Eastwood
Model	Throatless Shear
Serial #
Product Website
Instructions	Instructions
Size/Volume

About

• High performance motor
• Throatless design
• Tungsten carbide blade
• Cuts 18 gauge steel, 22 gauge Stainless and 16 gauge aluminum
• Clean Cuts with no burrs to sand like drilled holes

It features a high-performance, high-torque, ball bearing motor design with a replaceable blades and brushes for efficient operation and long life. Easily cuts up to 22 gauge stainless steel, 18 gauge steel, and 16 gauge aluminum. Throatless design allows tight curves to be cut with ease.

Safety

• Keep fingers clear of the blades – it cuts steel, so fingers are nothing to it!

Getting Started

Here’s a quick video showing the shear in use:

 

Materials

• Stainless Steel 22 gauge (0.03125 inches) and thinner
• Mild steel 18 gauge (0.050 inches) and thinner
• Aluminum and plastic 16 gauge (0.0625 inches) and thinner

Power and Speeds

3.5 amp motor

Tips and Tricks

Add other tips and tricks here

Notes

Add other notes here

Project Ideas

Knockout punch for making perfectly round holes in metal, including steel.

Owner	Fox.Build
Manufacturer	Liukouu
Model	SYK-8
Serial #
Product Website
Instructions
Size/Volume	8 Ton, 6 dies

About

The knockout punch is a hydraulic punch that can create perfectly round holes in metal, including steel up to 2mm thick.

Specifications:

• Application Range:22~60mm
• Tonnage:8T
• Plate Thickness:2mm
• Stroke:11mm
• Equipped Punch Dies
  • 22mm
  • 27.5mm
  • 34mm
  • 43mm
  • 49mm
  • 60mm

Safety

Add safety information and procedures. Can be a paragraph, bulleted list, numbered list, or any combination

• Keep fingers clear when operating either machine!

Getting Started

To knock a hole in a sheet of material:

1. Drill a pilot hole centered where the final hole should be centered. This hole needs to be large enough for the threaded shaft to go through.
2. Put the cup half of the punch on the threaded shaft attached to the pump.
3. Put the threaded shaft through the pilot hole and thread on the second half of the punch.
4. Close the valve on the pump and pump until the punch has completely made the desired hole.

Here’s a quick video showing the process:

http://

Materials

Steel, aluminum, brass, flexible plastics (may shatter brittle plastics).

Power and Speeds

The hydraulic pump supplies up to 8 tons of pressure.

Tips and Tricks

Add other tips and tricks here

Notes

Add other notes here